Buy Evinrude Outboard Parts

Announcement

Collapse
No announcement yet.

115 etec prop issues

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • 115 etec prop issues

    have a 15 '3" carabean comaro(fibregl***) with a 115 hp etec.
    Currently have a 13 7/8 dia SST 19 deg pitch and want to pull bigger skiers out a bit easier and was wondering what prop to use.

    Tried my old prop off old evenrude 100 which was a SST 13 inch dia with 19deg pitch and with vent holes, which I was told would do the trick. It got me off the mark a little better but then cavitated a lot when putting skier out on tight whip.
    Boat slowed to almost stop and engine revved to 4.5 k (note with both props engine was trimed down).

    Any ideas as I was recomended a 18 deg pitched Raker by a dealer which also has vent holes. I ***ume it would do the same get me off the mark better but would still cavitate on hard turns.

    Currently pulls 52 MPH at 5.7k revs

  • #2
    For more low end power use a smaller pitch prop, but will increase rpm's at full throttle.
    Regards
    Boats.net
    Evinrude Outboard Parts

    Comment

    Working...
    X