Hi all,
have a few questions about an 1989 E25ELCEB, with only about 30 hours on it,
#1, am installing a complete water pump kit (#80) is any gasket sealer required? and is there a torque setting on the pump housing?
#2, am replacing the flywheel nut because i had to remove it a few times to replace the power pack, is any type of locktite required? and what would you torque it down to?
#3, the washer is missing from the top of the br*** water tube, but is in the grommet tight and looks fine, is the washer necessary?
#4, have been using merc quicksilver mix at 50-1, with middle grade gas, is premium or regular gas recommended for this evenrude?
Thanks, Paul
have a few questions about an 1989 E25ELCEB, with only about 30 hours on it,
#1, am installing a complete water pump kit (#80) is any gasket sealer required? and is there a torque setting on the pump housing?
#2, am replacing the flywheel nut because i had to remove it a few times to replace the power pack, is any type of locktite required? and what would you torque it down to?
#3, the washer is missing from the top of the br*** water tube, but is in the grommet tight and looks fine, is the washer necessary?
#4, have been using merc quicksilver mix at 50-1, with middle grade gas, is premium or regular gas recommended for this evenrude?
Thanks, Paul
Comment