If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I was wondering how hard is it to take a long shaft & make it a short shaft ? It looks to me like I could just take off the extension piece & it would bolt right up to shorten it but I'm not sure. Does Anyone know how I would go about this ?
Find a parts break down for your motor and it should show the short and long shafts. I think that you have to change the drive shaft and water tube on some, maybe the shift rod.
Tweet
1974 25hp Evinrude #25402
Comment