Buy Evinrude Outboard Parts

Announcement

Collapse
No announcement yet.

200 johnson dies after 6 seconds

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • 200 johnson dies after 6 seconds

    need help have a 200 johnson starts up and runs for 6 sec. and dies like you turn the key off start it back up exackly 6 sec. dies again

  • #2
    What year is it? Sound like it runs till it comes out of quick start?
    Has it been sitting? If so it may have varnished carbs.
    Ck compression.
    Ck spark.
    Ck for water in fuel.

    Comment


    • #3
      its a 1996 set for 3 years put carb kits in check comp,130-125 all cyld.fuel is ok replaced water sep. no water in old sep. cust just had a crank installed by someone else per cust never ran right after that iam woundering about timming now..................all carbs are sync..

      Comment


      • #4
        Crankshaft was swapped ?
        Yes CK timing high & low speed
        Was fresh gas put in the tank?
        CK spark in & out of quick start.
        Did you try to set idle mixture screws?

        Comment


        • #5
          freash gas was installed,crankshaft was changed,idle mix screws are set at 6 turns out found them set at 11 turns out i changed it to 9 and it seem to stay running longer cant check timming cus it want run long enought but it seems after 6 sec. it loads up and dies cust wants to set fire to it but i would like to know whats going on

          Comment


          • #6
            Have you been able to watch timing light when it dies to CK spark all 6?
            Is there no trace of ground on black/yellow under pack with key on?
            Un hook shift switch & CK
            When it starts it should be in quick start at 1100 RPM

            Comment


            • #7
              i think we might have found it all the fuel rack hoses are coming apart on the in side and might be going flat and shutting off the fuel supply

              Comment


              • #8
                *** good find. Thanks for the update

                Comment

                Working...
                X