If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I would like to know if I have to take the starter motor off to be able to remove the carburator on my 30 horse Evenrude. If so, how do I remove the starter?
Thanks,
hightide
You will have to remove the starter bracket, starter ***y. Remove bolts holding throttle advance shaft, remove bolts from starter bracket to engine block and slide starter bracket forward over stud(in front above carb).
Thanks for your reply, I thought I would heve to get that starter out of the way. I was hoping for some trick but it didn't look like any way, just thought I would ask! Thanks again.
Comment