power tilt and trim removal

[jetblue319]

Hello,
I have a 97 Evinrude 225 and I am trying to remove the lower pin on the trim unit. I removed the top pin and now trying to remove the lower pin. I removed both "C" clips I have the engine on a engine stand and a engine hoist attached to power unit with a lift attachment. I applied heat with a propane torch and sprayed P blaster. No luck I used a small sledge hammer with a drive pin and it's not moving. I am able to move the unit about a inch or two, fore and aft. Any ideas out there? Any help appreciated
Jet

[Solarman]

I'm not to sure of this lower pin you're talking bout?

Post back, with pic if able.

[jetblue319]

In this photo, it's the pin just to the right on the lower left engine mount bolt.
Will get better picture
Jet

[jetblue319]

Here is a better picture, its the brown pin, below the left lower engine mount
Jet

[jetblue319]

Well I got the lower pin loose from the trim unit that goes into the stern bracket, but I need to remove the stern bracket / tilt tube to remove the power tilt/ trim unit. The manual says a sliding hammer and tilt tube serving kit is needed. Anybody have any better way to remove the stern bracket.