Tweet
so i my 50 hp ETEC could not break past 10000 rpm i noticed it needed oil so i poured what i had in the tank. i noticed that it was 4 stroke (idk how it got in my boat) so i cyphened it out after running it for a few min not knowing ,i then poured in 2 stroke quick silver oil. it started up but the issue remained that it would not get over 10000 rpm the boat was very slow. so i checked the throtle and everything was moving and working correctly on that end when i would go full forward the rpm would not go up and it would just bog out, should i switch the plugs? if so what kind of plugs
-
-
slow rpm
Low oil will not activate slow mode. There must be another reason for this. Need to check codes stored, dont think little bit of four stroke oil would be any more than a temporary problem unless sensor says no oil. pull battery lead for a few then reconnect, might work, Double check everything. -
how would i go about checking the codes.Comment
-
figured out the issue the lack of power was from the throttle positioning sensor all i had to do was adjust the throttleComment
Comment