Buy Evinrude Outboard Parts

Announcement

Collapse
No announcement yet.

motor wont turn off

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • motor wont turn off

    I have a 1992 evinrude 175 I put a new rectifier on today and started it up on the hose and ran fine but when I turned key to off position the motor would not stop running. It ran rough in the off position but would not turn off I had to choke it out to kill it.

  • #2
    I believe the off position of key switch and kill switch operate by grounding the current going to cdi, might check the wiring diagram, but if there is a poor/bad ground related to those wires it wouldn't shut down. Also, check those same wires, may have corroded or broken somewhere?

    Good luck, post back if find anything.

    Comment


    • #3
      If its the same as my 1991 150hp it would be a black and yellow wire that goes to the ignition module. My prints show a connector in the engine area with two black/yellow wires to the module. Hope it helps!

      Comment

      Working...
      X