Tweet
I recently pulled an old wooden skiff out of my mom's garage that had been sitting for about 9 years. It has a 1996 evinrude 9.9 short shaft on it. It was only used for two seasons when I was a kid and it always ran great. After 9 years, it started on the fourth pull and ran as if it was brand new (used water muffs in the backyard). I took it out on the connecticut river and had no problems whatsoever. The next time I took it out, it would stall when I tried to idle. I was having trouble with a crappy fuel line from amazon, so I replaced the fittings and primer bulb. That took care of the leaks, but it still wouldn't idle. I cleaned out the carb and fuel pump and installed rebuild kits for both. I installed new fuel lines in the motor. I installed new spark plugs. Still wouldn't idle no matter what I did with the mixture screw. I set the idle screw to give it a little more throttle at idle speed and that seemed to help it idle on the water muffs. I put the boat in the water and it wouldn't idle for more than a couple seconds. If I quickly put it in gear and give it the throttle, I can motor around all day long. As soon as I cut back to idle, it's dead again. I'm quite confused. I don't think there's anything left in the fuel circuit to replace except the fitting on the engine side. I don't understand why it ran so beautifully the first day and now it wont't idle. It takes a lot more effort to start it as we'll. I find that if I keep playing with the choke, I can keep it alive. I choke it until it starts sputtering out, then I unchoke it and it revs up for a second before sputtering out again, then choke again, etc, etc. Seems too easy to blame the ethanol since it ran fine at first. I've replaced all the gaskets in the carb and fuel pump and they looked fine. I am at an utter loss for what the problem is. Can anyone help?