If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
water got into trim system disasimbled got all fluid out need to know how to go about bleeding system got it to moving up and down with no load on it help?
Open manual release screw on side of trim unit, raise all the way up by hand, fill with fluid, let it go down all the way, raise back up by hand and check fluid.
Repeat a couple of times till don't get any air out of fill cap when remove.
Tweet
Comment