Tweet
I have a 92 Evinrude V4 140 HP on Ranger B*** boat and the motor runs great except for when im reading to take off out the hole shot, when i trim the motor all the way down..its runs very rough and then once i gun the throttle it takes 2-3 seconds for it really to get going. once it plains out it then runs fine again and idling with trim up runs fine. any thoughts?
-
-
Are the exhaust relief holes on back of mid section going under water? -
I don't believe so, no. I would have to check again, but if they were, how would that be fixed? And would that solve the problem?Comment
-
Then the motor is sitting too low in water, raise motor if possible or redistribute weight in boat so dont sit so low in water.Comment
-
there is hardly any weight in the boat besides the boat itself and the motor...how would i go about raising the motor? and if i can't what other options do i haveComment
-
How much would it need to raised to get ex holes out of water?, Is the anti-ventalation plate on gearcase even with bottom of hull or below it?Comment
-
what exactly do you mean by that. i'm not familiar with those terms. could anything else be causing this besides the setup of the motor?Comment
-
Put boat in water, Mark the water line on boat and take it to your local dealer and ask the for suggestionsComment
Comment