ok i have a 1981 e90tlcim 90hp v-4. first i will tell you the problem then what i have done so far to correct it. first off cold or hot does not matter. actually maybe the problem is less persistant while cold. but engine starts and idles perfect. i can go to engage in forward or reverse makes no difference, and the engine stalls doesnt sputter just dies. i can immediatelt restart it and either run the fast idle for a minute or two then take off or i can fire it up and press the key in (electric prime/choke) as i engage the throttle and it will pick up and go on and run WOT with no issues. i can run WOT all day with no more issues. but as soon as i park (or switch off) for a while i have to go thru the same steps again to get it to take off. and its getting aggravating really quick. on muffs of course it runs flawlessly. but in the water i have this problem. now to clarify what i have done and tried so far. cleaned carbs, rebuilt carbs, replaced fuel lines, checked float setting, checked firing, compression tested hot and cold., cleaned carbs again found obstruction in mid range jet, still no difference, tried fresh fuel, did a lync and sync, checked timing advance, checked fuel pump, replaced plugs. by the way the primer bulb stays hard and squeezing the primer bulb doesnt help when its acting up. and this is a consistant problem not oc***ional. and seems to be worse when the engine warms up. its almost like a really bad cold start everytime i crank the engine. now any suggestions are helpful. again engine idles perfect and runs WOT perfect. just stalls upon take off.
Announcement
Collapse
No announcement yet.
stalling when engaging in gear
Collapse
X
Comment