E30 died and won't start

[StxFishing]

Hey all, I was out in my little skiff with a 6/2011 E30DRSINC. Ran fine going out. Died on way in. Won't start with a no spark condition. I checked main fuse. Has good power through it. I have no voltage at coils when cranking and no indicator lights at emm either. Any ideas? I'd like to fish this weekend if possible. Any direction would be greatly appreciated!

[boats.net]

That engine has a TCI type ignition with a start ***it circuit but if the EMM lights are not coming on then check for 12 volts at purple wire to EMM, check ALL GROUNDS, check for 55 VAC(Stator output, start ***it circuit) on white red wire when cranking engine over.

[StxFishing]

Originally posted by boats.net View Post

That engine has a TCI type ignition with a start ***it circuit but if the EMM lights are not coming on then check for 12 volts at purple wire to EMM, check ALL GROUNDS, check for 55 VAC(Stator output, start ***it circuit) on white red wire when cranking engine over.

No voltage at purple wire. As far as white/red wire, is thst at the emm as well? I don't see that color at stator harness. I see a 2 wire connector at top of flywheel cover and I see one at emm with white/red wire.

[boats.net]

The 12 volts on purple is with key on, if have no voltage with key on then may have a bad fuse, key switch or wiring between key switch and engine..
The white/red wire is coming out of EMM, but need to repair purple wire first.

[StxFishing]

Originally posted by boats.net View Post

The 12 volts on purple is with key on, if have no voltage with key on then may have a bad fuse, key switch or wiring between key switch and engine..
The white/red wire is coming out of EMM, but need to repair purple wire first.

It's a tiller steer. It doesn't have a key. I checked purple wire while cranking. I can't find the purple wire anywhere but at emm and at duetch connector test harness. There's no purple wire at start button or anywhere else on tiller. I don't know where else to check

[boats.net]

On a tiller model disconnect the black/yellow wire(stop circuit) from EMM and recheck spark. Test system voltage(red/white wire)for 55vac output.