2yr cold start

[cfh1177]

I have a 1988 Evinrude 20hp, E20CRCCA. It hasn't been started in two years. I installed new plugs, replaced the lower unit grease and ordered a new water pump. I also installed a fuel/water separator. I'd like to start the motor this weekend to check it out before putting in the new water pump.

My question is should i take the carb apart and clean it first or just spray some carb cleaner inside? If i'm ok with the carb cleaner, do i spray inside FIRST before i start the OB or start the OB first and spray while it's running or both?

Thanks,
Mark

[cfh1177]

in another forum it was suggested to just take out the spark plugs and put a couple drops of 2 cycle oil in the cyliners give it a couple of cranks to lube inside and not to use the carb spray unless there's a problem. Does that sound right?

[boats.net]

Yes and run on double oil mix until running good.