Tweet
Hello
Looking after a little help with diagnosing problem with motor.
I find it hard to start since I bought it. At first I thought it was the primer solenoid not working but last tiem I went out I could hear it clicking in when turning the key.I am thinking now that the issue is possibly that it is putting too much in and flooding because when I try and run the engine it takes a good 10-15 minutes to get her goin. Usually the way I get it to run is by either waiting a bit of time after priming or what I did last time was splash a bit of metho into the air intake and it fired up first time. Also the fuel line bulb, once squeezed till firm goes down a bit so its semi soft again if that helps
Any suggestions would be appreciated...
Prob needs a carb rebuild or possible fuel pump/solenoid issue ?
What are your thoughts...
Looking after a little help with diagnosing problem with motor.
I find it hard to start since I bought it. At first I thought it was the primer solenoid not working but last tiem I went out I could hear it clicking in when turning the key.I am thinking now that the issue is possibly that it is putting too much in and flooding because when I try and run the engine it takes a good 10-15 minutes to get her goin. Usually the way I get it to run is by either waiting a bit of time after priming or what I did last time was splash a bit of metho into the air intake and it fired up first time. Also the fuel line bulb, once squeezed till firm goes down a bit so its semi soft again if that helps
Any suggestions would be appreciated...
Prob needs a carb rebuild or possible fuel pump/solenoid issue ?
What are your thoughts...
Comment