I'm new to this forum - so not sure I'm in the right place for this question - but I've got a new Etec 25 hp (SWEET motor), and want to put my Tiny Tach on it. I googled up some older posts and see that it's been done, and the the preferred location for the wire is the lower spark plug but that the upper plug (MUCH easier to access) works too.
My question is - what do I attach the ground wire to? The factory installed ground appears to be 28 gauge or so (thinner than my thinning hair) and is only about 10" long, so I don't have much reach from the connection location. I can extend the ground if necessary, but slicing such a small wire is something I'd rather not do.
[/IMG]
My question is - what do I attach the ground wire to? The factory installed ground appears to be 28 gauge or so (thinner than my thinning hair) and is only about 10" long, so I don't have much reach from the connection location. I can extend the ground if necessary, but slicing such a small wire is something I'd rather not do.
[/IMG]
Comment